Orbit ArizonaMist Manual De Instrucciones página 2

Troubleshooting (Continued)
Problem Solution
Leak in Tubing If a leak occurs in the actual tubing itself (not the point where
the tubing meets the fitting), the tubing must be replaced
where the leak has occurred.
Leak at Nozzle 1. Make sure the nozzle is sufficiently tightened into place.
HAND TIGHTEN ONLY DO NOT USE TOOLS.
2. Check to make sure the nozzle O-ring is in place.
3. Nozzle may be clogged which can give the appearance of
"leaking" or dripping. Clean with nozzle cleaner.
Leak at Slip-Lok Fitting 1. Remove tubing from Slip-Lok and look inside each end to make
sure that the O-ring is in place.
2. Remove tubing from Slip-Lok and check tubing. There should
be a line scored around tubing exactly 1/4 in. from the end of the
tubing. If not, tubing has not been inserted past the O-ring in the
fitting. Re-insert tubing correctly - push and twist.
3. Any horizontal scoring of the tubing could cause leaking.
Trim the tubing above any scoring marks with a clean vertical
cut and re-install tubing correctly. DO NOT USE SCISSORS.
System Expansion /Accessories
3/8 in. Professional System kit can be easily expanded up to 62 nozzles/125 ft. of mist line by
adding additional Slip Lok T Fittings, clamps, and tubing. Simply remove the end plug from
the last Slip Lok T Fitting of your existing mist line and add tubing, clamps, and fittings to
your desired length.
Picture Part # Product Description
Nozzle Plug - Use to close
10107
unneeded misting outlets
Calcium Inhibitor Filter - Attaches directly to 3/4 in. hose
10109
bib Protects nozzles from clogging due to sediment
Nozzle Cleaner - 8 oz. bottle. Used to
10103
dissolve mineral deposits on nozzles
Slip-Lok Elbow - Used wherever a clean
92110
90 degree turn is needed in mist line
3-Way Slip-Lok T - Allows you to split mist
92120
system and run in multiple directions
92225,
3/8 in. Flexible Tubing
92228
Brass and stainless steel
10106
nozzles available as replacements
Slip-Lok T - Fittings with nozzles are available
10121
to expand your mist system
20001
Stucco Installation Kit
92100
Booster Pump
10115
Auto Drain Valve
Warranty and Statement
Orbit Irrigation Products, Inc. warrants to its customers that its Orbit/Arizona Mist products
®
will be free from defects in materials and workmanship for a period of four years from the
date of purchase. We will replace, free of charge, the defective part or parts found to be
defective under normal use and service for a period of up to four years after purchase (proof
of purchase required). We reserve the right to inspect the defective part prior to replace-
ment. Orbit Irrigation Products, Inc. will not be responsible for consequential or incidental
®
cost or damage caused by the product failure. Orbit liability under this warranty is limited
®
solely to the replacement or repair of defective parts.
To exercise your warranty, return the unit to your dealer with a copy of the sales receipt.
Questions please call: 1-800-488-6156 or 1-801-299-5555
www.orbitonline.com
Register your product online at www.orbitonline.com
Orbit Irrigation Products Inc.
®
845 N. Overland Rd.
North Salt Lake, Utah 84054 USA
http://www.orbitonline.com
800-488-6156
801-299-5555
P/N 11760-24 Rev C
1
2
3
4