Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Owner's Manual
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
1.
Before you use your battery charger, be sure to read all
instructions and cautions printed on:
• Battery Charger
• Battery
• Vehicle or unit using battery
2.
Use battery charger on LEAD ACID type rechargeable bat-
teries only, such as used in autos, trucks, tractors, airplanes,
vans, RVs, trolling motors, etc. Charger is not intended to
supply power to low-voltage electrical system other than in
an automotive application.
WARNING: Do not use battery charger for charging dry-
cell batteries that are commonly used with home appliances.
These batteries may burst and cause injury to persons and
damage to property.
3.
Use only attachments recommended or sold by manufac-
turer. Use of non-recommended attachments may result in
fire, electric shock, or injury.
4.
When disconnecting the battery charger, pull by the plug
not by the cord. Pulling on the cord may cause damage to
cord or plug.
5.
Locate battery power cord so it cannot be stepped on, tripped
over, or subjected to damage or stress.
6.
Do not operate charger with damaged cord or plug. Have
cord replaced immediately.
7.
Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to a
qualified professional for inspection and repair.
8.
Do not disassemble charger. Take it to a qualified profes-
sional when service or repair is required. Incorrect reas-
sembly may result in electric shock or fire.
9.
To reduce risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning.
10. Do not use an extension cord unless absolutely necessary.
Use of an improper extension cord could result in fire or
Important Safety Instructions
GENERAL BATTERY SAFETY
SCHUMACHER ELECTRIC CORPORATION
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485
Battery
Charger
Model:
–Save–
electric shock. If an extension cord must be used, make
sure that:
• Pins on plug of extension cord are the same number,
size, and shape as those of plug on charger.
• Extension cord is properly wired and in good electrical
condition.
• Wire size is large enough for AC ampere rating of charger,
as specified below:
Length of cord (feet):
AWG size of cord:
11. Always charge battery in a well ventilated area.
NEVER operate in a closed-in or restricted area without
adequate ventilation.
WARNING: Risk of explosive gas.
12. Locate charger as far away from battery as DC charger
cables permit.
13. Do not expose charger to rain or snow.
14. NEVER charge a frozen battery. If battery fluid (electrolyte)
is frozen, bring into a warm area to thaw before charging.
15. NEVER allow battery acid to drip on charger when reading
specific gravity or filling battery.
16. NEVER set a battery on top of charger.
17. NEVER place charger directly above battery being charged.
Gases from battery will corrode and damage charger.
18. NEVER touch the battery clips together when the charger
is energized.
19. NEVER crank engine with charger attached to battery.
WARNING: Battery chargers get hot during operation and
must have proper ventilation. Air needs to flow around en-
tire charger. Do not set on flammable items like carpeting,
upholstery, paper, cardboard, etc. Will damage leather and
melt plastic and rubber.
1
SS-51A-PE, 10 Amp
Fully Automatic Battery Charger
For 12 Volt Marine Deep Cycle &
Automotive Batteries
25
50
18
18
100
150
16
14
00-00-000558/0103

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Schumacher Electric SS-51A-PE

  • Página 1 SS-51A-PE, 10 Amp Battery Fully Automatic Battery Charger Charger For 12 Volt Marine Deep Cycle & Model: Owner's Manual Automotive Batteries –Save– Important Safety Instructions Read Rules for Safe Operation and Instructions Carefully Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation.
  • Página 2: Preparing To Charge

    PERSONAL PRECAUTIONS AND SAFETY 1. WARNING: Wear complete eye protection and clothing 5. Remove all personal metal items such as rings, protection when working with lead-acid batteries. bracelets, necklaces, and watches when working with a lead-acid battery. A lead-acid battery can produce a 2.
  • Página 3 BATTERY CHARGER CONTROLS D C AMPS IO AMP FULLY AUTOMATIC CHARGED CHARGING 10 12 BATTERY CHARGER CHARGE COMPLETE MANUAL AUTOMATIC FIGURE 3 CHARGER CONTROLS MANUAL-AUTOMATIC SWITCH NOTE: Some batteries, especially those with a built in state of Charging may be either Manual or Automatic. charge indicator and have been deeply discharged, may require the use of the MANUAL position in order to obtain full charge.
  • Página 4: Circuit Breaker

    READING METER D C AMPS D C AMPS D C AMPS CHARGED CHARGING CHARGED CHARGING CHARGED CHARGING CHARGE COMPLETE CHARGE COMPLETE CHARGE COMPLETE FULLY DISCHARGED BATTERY APPROACHING FULL CHARGE FULLY CHARGED BATTERY Initial charge current to the battery Charge current to the battery is typi- Charge current to the battery is 0 is typically 10 Amps.
  • Página 5 Check polarity of battery posts. Battery case will be marked NEGATIVE POSITIVE by each post: POSITIVE (POS, P, +) and NEGATIVE (NEG, N, -). NOTE: The positive battery post usually has a larger BATTERY CHARGER diameter than the negative post. BATTERY Attach a 24-inch long (or longer) 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG, N, -) battery post.
  • Página 6: Troubleshooting

    TROUBLESHOOTING The battery charger is designed to work automatically. However, If a problem does occur, check the following: PROBLEM POSSIBLE SOLUTION No meter reading. Charger is not plugged in Plug in Connections are reversed. With charger unplugged, reverse clamps and reconnect (rock back and forth to bite in).
  • Página 7 WARRANTY IS NOT TRANSFERABLE. NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS PRODUCT AND EXPRESSLY EXCLUDES Schumacher Electric Corporation warrants this battery SUCH FROM THIS LIMITED WARRANTY. charger for two years from date of purchase at retail against defective material or workmanship.
  • Página 8: Important Safety Instructions

    • IMPORTANT SAFETY INSTRUCTIONS • • SAVE THESE INSTRUCTIONS • ELECTRIC CORPORATION 801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179 Send Warranty Product Repairs to: 1025 E. Thompson Avenue, Hoopeston, IL 60942-0280 Call Customer Service if you have questions: 1-800-621-5485...
  • Página 9: No Destruya Este Manual-Instrucciones Importantes De Seguridad

    Cargador SS-51A-PE, 10 Amperios 12 Voltios de bateria Cargador de Acumuladores Modelo: Manual del Usuario –No destruya este manual– Instrucciones Importantes De Seguridad Lea con detenimiento estas instrucciones y reglas para utilizarlas con seguridad. El trabajar cerca de baterías de plomo-ácido es peligroso. Las baterías generan gases explosivos durante su operación normal.
  • Página 10: Precauciones Y Seguridad Personales

    PRECAUCIONES Y SEGURIDAD PERSONALES ADVERTENCIA: Al trabajar con baterías de plomo-ácido, Al trabajar con una batería de plomo-ácido, quítese todos use protección completa de los ojos y protección de la ropa. los artículos personales de metal tales como anillos, Cuando usted trabaje con o esté cerca de una batería de brazaletes, collares y relojes.
  • Página 11 CONTROLES DEL CARGADOR DE ACUMULADORES D C AMPS IO AMP FULLY AUTOMATIC CHARGED CHARGING 10 12 BATTERY CHARGER CHARGE COMPLETE MANUAL AUTOMATIC MANUAL-AUTOMATIC SWITCH NOTA: Con algunos acumuladores, en especial los que tienen INTERRUPTOR MANUAL-AUTOMATICO incorporados indicadores de carga y que han sido cargados Se puede cargar manual o automáticamente.
  • Página 12: Lectura Del Amperimetro

    LECTURA DEL AMPERIMETRO D C AMPS D C AMPS D C AMPS CHARGED CHARGING CHARGED CHARGING CHARGED CHARGING CHARGE COMPLETE CHARGE COMPLETE CHARGE COMPLETE ACUMULADOR COMPLETAMENTE AL LLEGAR A LA CARGA ACUMULADOR COMPLETAMENTE DESCARGADO. La corriente de carga COMPLETA. La corriente de carga al CARGADO.
  • Página 13 Inspeccione la polaridad de los postes de la batería. La POSITIVO NEGATIVO caja de la batería estará marcada por cada poste: POSITIVA (POS, P, +) y NEGATIVA (NEG, N, -). NOTA: El poste CARGADOR positivo de la batería generalmente tiene un diámetro mayor CORDON ACUMULADOR ELECTRICO...
  • Página 14 DETECCION DE DESPERFECTOS El cargador de acumuladores está diseñado para funcionar automáticamente. Sin embargo, si ocurre un problema, verifique lo siguiente: PROBLEMA CAUSA POSIBLESOLUCION No hay lectura del medidor. No está enchufado el cargador. Enchufe el cordón. Las conexiones están al revés. Con el cargador desenchufado, invierta las pinzas (rayándolas para que hagan buen contacto);...
  • Página 15: Instrucciones De Mantenimiento Y Limpieza

    DISTINTA A ESTA GARANTIA EXPRESA LIMITADA. EL FABRICANTE TRANSFERIBLE. NO OTORGA NINGUNA GARANTIA DE COMERCIALIZACION O Schumacher Electric Corporation garantiza este cargador de batería ADAPTABILIDAD DE ESTE PRODUCTO Y EXCLUYE EXPRESAMENTE por dos años a partir de la compra minorista por material o mano de obra AQUELLAS DE ESTA GARANTIA LIMITADA.
  • Página 16: Instrucciones De Seguridad Importantes

    • INSTRUCCIONES DE SEGURIDAD IMPORTANTES • • GUARDE ESTAS INSTRUCCIONES • ELECTRIC CORP. 801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179 Para reparación del producto baja garantía, envíelo a:1025 E. Thompson, Hoopeston, IL 60942-0280. Para más información comuníquese al Dep. de Servicios al Cliente: 1-800-621-5485...

Tabla de contenido