Andersen Frenchwood 400 Serie Guia De Inicio Rapido página 8

4. Install Trim Set
• Reinstall Trim Set by reversing procedure in Step 1.
5. Check Handing of Latch and Operation of Lock Mechanism
• Check position of Latch. If Latch needs to be reversed,
proceed with bullets below.
• Insert a 1/8" flat blade screwdriver into Latch Reversal
Hole until it bottoms out.
• Apply downward pressure on screwdriver handle while
pulling Latch up and out, as shown.
• Remove screwdriver from Latch Reversal Hole.
• Grasp Latch, pull outwards slightly, and rotate 180°.
Position Latch so that sloped portion contacts Latch
Receiver first.
• Push Latch back into Lock Mechanism Housing.
▶ Lock mechanism replacement procedure is complete.
Latch Reversal Hole
Flat Blade Screwdriver
Up
Latch
8
Latch
Latch
Lock
Mechanism
Housing