Cadet softHEAT EBKN Guía Para El Propietario

OWNER'S GUIDE
FIGURE 1: Remove Junction Box Cover
When using electrical appliances, basic precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons, including the following:
Read all instructions before using this heater and thermostat.
All electrical work and materials must comply with the National Electric Code (NEC), the
Occupational Safety and Health Act (OSHA), and all state and local codes.
If you are uncomfortable working with electrical appliances, unable to follow these guidelines,
or do not have the necessary equipment; consult a licensed electrician.
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from turning on power while you are working on
the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
TEL: 360-693-2505 www.cadetco.com P.O. Box 1675 Vancouver, WA 98668-1675
EBKN THERMOSTAT
Description
The EBKN end cap thermostat kit is an accessory for
the EBHN Series of hydronic baseboard heaters.
This kit will provide thermostatic control of the heater
in place of a wall mounted thermostat.
Note: The EBKN end cap thermostat is designed to
control only one EBHN heater unit.
If using for an older model EBHA unit, use the
provided alternate junction box cover to adapt.
Tools Required: Phillips Screwdriver, Insulated Wire
Connectors (Wire Nuts
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
® ), Strain Relief Connector
Figure 2: Junction Box
Cover Adapter
For EBHA Series