Step 2:
20' of ¾" kink-free tubing is included in this kit.
Tubing must be cut to length on site based on
the requirement of the installation. Begin by
installing one end of the tubing to the outlet
of the 3-Way Diverter that is closest to the center
of the basin. Loop the tubing into the first
plumbing channel and cut it to the desired length.
Insert the barbed end of the ¾" elbow into the
open end of the tubing. Repeat this process for
the remaining diverter outlets.
Step 3:
Place the decorative items such as vases, columns or
cored boulders on the fountain basin and position
directly over the ¾" elbows. Run the ¾" PVC standpipe
(not included) through the decorative item and
into the socket end of the ¾" elbow. Seal the
opening around the standpipe with the supplied
Standpipe Sealant. SPSEAL Standpipe Sealant is an
EPDM based product that will remain pliable and
can be reused. With heavier items such as cored
boulders it may be easier to set the standpipe
into the elbow first before installing the
standpipe into the boulder.
Atlantic's FB3200/FB4600 Fountain Basins have a
recessed pocket that allows 1½" conduit sleeves
to be installed within the circumference of the
basin without notching for the pump cord
and low voltage wiring. A 1½" cord stopper is
included to plug the top of the sleeve to prevent
gravel and other debris from entering the conduit.
Warranty
This product carries a one-year warranty. This warranty is extended solely to the
original purchaser commencing from the date of original purchase receipt. A misused or
abused product voids this warranty.
Warranty Claims
In case of warranty claims, the complete Kit should be returned to the place of purchase
accompanied by original receipt.
4
3/ 4 " KINK FREE
TUBING
3/ 4 " PVC
STANDPIPE
(not included)
STANDPIPE
SEALANT
3/ 4 " INSERT X 3/ 4 "
SOC 90˚