Attaching Connection Cable For Left Or Right-Hand Operation; Important - Rockwell Automation MobileView Instrucciones De Instalación

Attaching Connection Cable for Left or Right-Hand Operation

You can attach the MobileView Connection Cable on the left or right side of the
terminal for either left or right-hand operation. To relocate the cable, simply grasp
the strain relief and/or the plug and slide off of mount with a rocking motion.

IMPORTANT

Avoid routing cable
over T-support.
Connection Cable
Make sure the K3, 11-pin female connector clicks completely into
the S19, Main Connector when plugged in. Ensure proper seating
of the K2, 8-pin RJ-45 jack into the S4, Ethernet Connector.
To avoid pinching the cable with the back cover, avoid laying
cable on top of the T-supports.
After routing the cable, secure the back cover to the terminal
with the 6 screws. Tighten screws to a torque of 4.42 in-lbs to
maintain IP54 degree protection.
Attaching Cable on Right
Main Connector (S19)
Attaching Cable on Left
Main Connector (S19)
MobileView Connection Cable
S4, Ethernet Connector
S4, Ethernet Connector
Avoid routing cable
over T-support.
Connection Cable
Publication 2727-IN004C-MU-P
7