Lighting Instructions - Real Flame Bryon C12700LP Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Using the Ignitor

1. Read and understand all operating instructions

2. Burner control knob must be in the OFF position.

3. Connect propane (LP) cylinder (see above pages).

4. Slowly open valve on LP gas cylinder.

5. Push and hold igniter button

6. While holding the igniter button with one hand, use

your other hand to push and turn the control knob

to the LIGHT position to light the burner.

7. Keep Burner Control Knob pressed in for 15-30 seconds after ignition.

8. If ignition does not occur in 30 seconds, turn control knob to the OFF position and turn

gas o at the source, wait 5 minutes until gas has cleared and repeat lighting procedure.

9. After lighting, rotate the Burner Control Knob counter clockwise to LOW setting.

Observe ﬂame, make sure all burner ports are lit. Flame height should be no higher than

13 inches tall.

10. Adjust the ﬂame to the desired height with the

control knob.

If battery is dead you may TEMPORARILY use

a long match or extended butane lighter

If doing so:

1. Wearing heat-resistant gloves, position the burning

long match or extended lighter near the side of

the burner. DO NOT lean over the ﬁre table while

lighting.

2. Turn control knob counterclockwise to LIGHT.

3. Remove long match/extended lighter.

4. After lighting, rotate the burner control knob counter

clockwise to LOW setting. Observe ﬂame; make sure

all burner ports are lit.

5. Adjust the ﬂame to the desired height with the

control knob.

6. Replace the battery as soon as possible.

WARNING

If burner ﬂame goes out during operation,

immediately turn the control knob OFF and let the

gas clear a minimum of 5 minutes before attempting

to re-light the ﬁreplace.

Please refer to the trouble shooting pages for

additional support, beginning on page 17.