Top View - PEERLESS PARAMOUNT PPA Manual Del Usuario

Attaching Adapter Plate to Projector Mount (continued)
Using 4 mm security allen wrench (N), loosen the eight screws on
5
adapter plate (O) (shown in figure 5.1) one full turn to allow for ad-
justments of channels.
Place projector upside down and locate mounting holes. If there are
only three mounting holes remove fourth channel from adapter
plate. Center adapter plate (O) over the center of gravity of the pro-
jector while aligning mounting holes on channel feet with mounting
holes on projector as shown in figure 5.2 and figure 5.3.
Note: Be certain hook slots of pivot/roll bracket (F) face to the
back of the projector as shown in figure 5.3.
Important: If projector does not have at least three mounting holes,
do not use this adapter plate.
fig. 5.2
Attach adapter plate (O) to projector using one screw
5-1
(P, Q, R or S) for each channel as shown in figure 5.4. Tighten all
screws, while keeping the adapter plate centered. Be sure that
adapter plate and pivot/roll bracket (F) are in the correct position.
Adjust the feet of the channels to keep the adapter plate level.
Tighten all screws with 4 mm security allen wrench (N) while keep-
ing the center of gravity. If M3 screws (P) are used, tighten using 2
mm security allen wrench (U).
Note: Projectors will require different size screws for mounting.
Use a combination of screws (P, Q, R or S) and foot adjustment
that will result in channels of adapter plate (O) fitting tightly against
projector. Important: In order to properly engage the threads in
the mounting holes, the screw must be turned at least 3 full turns.
Note: If using screw (P), place washer (T) between screw and foot
of channel.
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
Visit the Peerless Web Site at www.peerlessmounts.com
generic Projector

TOP VIEW

CAUTION
fig. 5.1
fig. 5.3
Channel
Channel
Foot
Mounting
Hole
O
fig. 5.4
8 of 33
For customer care call 1-800-865-2112 or 708-865-8870.
Hook slots face to the
back of projector
F
O
P, Q, R or S
ISSUED: 12-26-07 SHEET #: 055-9494-1
Loosen one full
turn for channel
adjustments
O