Ezviz LC1 Guia De Inicio Rapido página 6

Step1
Shut off the electricity at the breaker that controls security light's circuit.
Step2
Separate the base plate from the security light camera.
1. Unscrew the 3 base screws.
Base screw
Step3
Fix the base plate to the wall.
1. Pick a clean and flat surface.
2. Drill two holes and insert anchors.
3. Fix the base plate to the wall with o-ring and mounting screws.
Anchor
When installing the base plate, make sure the logo (UP) faces upward.
Recommended Installation Height: 10 feet (3 m) above the ground.
Recommended Drill Bit: Ø6 spec drill bit.
Recommended Hole Depth: 0.13 feet to 0.14 feet (40 to 43 mm).
Security Light Camera Installation
2. Pull the security light camera off the base plate and unplug the
3-wire connector from the base.
3-wire connector
O-ring Mounting Screw
2
3. After separating the base plate from the camera, the effect picture is
shown as below.
UP