Norcold 640503 Guia De Inicio Rapido

Kit Contents: K1, K2, K3, K4, K5
K1
New Ref. Description
K1 Template
K2 Hinge Support Bracket
K3 Hinge Support Mounting Screw (2x)
K4 Plastic Hinge Support
K5 Spacer
NI A Bottom Bracket of Refrigerator
NI B Hinge Pin
NI Not Included: Reference Only
Tools Needed:
■ Power Drill with 7/64 inch Drill Bit
■ #2 Phillips Screwdriver
■ Refrigerator Service Manual
This procedure is to be performed by
WARNING
!
authorized service personnel only.
ATTENTION
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage.
Install Part
These instructions show the door hinges
NOTICE
on the right hand side of the refrigerator
and the side of
If the door hinges are on the left hand
side of the refrigerator, use the side of
K1
1. Pull the bottom trim piece off the refrigerator.
A
2. Put in position so it is resting on the bottom of the enclosure and is
K1
against (Fig. 2).
A
3. Using K1 as a guide, mark the location of the two (2) holes in
front of the enclosure.
P.O. Box 1285
Ann Arbor, MI 48106
www.norcold.com
N10 - Hinge Support Bracket
K2
marked "R".
K1
marked "L".
Fig. 2
K1
K1
Questions 1-800-543-1219
K3
Fig. 1
4. Remove and drill a 7/64 inch hole at each of the locations marked onto
K1
the front of the enclosure (Fig. 3).
5. Using (2x), attach
K3
6. Measure the gap between the top of the door and the center hinge.
• If the gap is 1/8 inch or less, push
use K5 (Fig. 4).
• If the gap is more than 1/8 inch:
• Remove the door.
• Push
K4
• Put
K5
• Reinstall the door.
onto the
Service Kit
K4
Fig. 3
K3 K2
to the front of the enclosure.
K2
Fig. 4
onto the bottom hinge and do not
K4
onto the bottom hinge.
onto .
B
Part No. 640502A (02.10.2020)
640503
K5
B
K5
K4