Publicidad
-
INFO SYSTEM MENU: In case the handset has display, pressing C+OK+1+OK will give us access to the internal settings menu :
X: 12 – The Intercom MONITOR address will be the number 12 (from 1 to 15).
o
M: 1 – MONITOR set as MASTER. A 0 will indicate SLAVE.
o
A:1 – Selfstarting enabled. A 0 will indicateit is disabled
o
0>> – Press "0" to see more system information.
o
N: 1 – The MONITOR has the nº 1 as ID for "Panel Calls". It could also be the nº 2 (switch-5)
o
I: 1 – Only Intercom mode enabled. A 0 will indicate it is disabled (switch-6 )
o
R: 1 – Only Reception mode enabled. A 0 will indicate it is disabled ( switch-7)
o
P: 1 – Priority mode enabled. A 0 will indicate it is disabled (switch-8)
o
Intercom Functioning:
STANDBY:
·
Handset hung up, blue led ON and keyboard leds OFF.
o
Make a call:
·
Pick up the handset (the blue led will start flashing and the display will turn on), enter the TELEPHONE/MONITOR number we wa
o
call and then press OK.(i.e., Call nº3)
General Call. With the handset hung up, keep the KEY button pressed for 2s. The blue and green leds will blink quickly and when
o
lifting the handset up, a call will be made to all the TELEPHONES/MONITORS that have the
show the symbol "*" that will turn into the number of the first TELEPHONE/ MONITOR that picks up.
If we have already pressed the KEY button during 2 seconds and we want to return to the standby mode without performing a cal
o
we can press the AUTO button, or pick up and hang up quickly, or just wait 30s. The blue led should retur n to its original blue light.
Receive a call:
·
While the handset is hung up, the MONITOR can receive calls. It will start ringing for up to 30s and the blue led will flash quickly. We
o
may terminate the call pressing the AUTO button, or just lift the handset up to start the conversation. At this point, the blue led will
flash slower and we will have audio at least for 90s (see "CONVERSATION LENGTH " in features).
SÍMBOLOS EN PANTALLA - SYMBOLS ON SCREEN
Comunicación con placa
Communication with panel
Apertura de puerta
Door opening
Conversación
Conversation
§
Pick up the handset, press nº 3 and then OK. If the TELEPHONE/MONITOR nº3 exists, the green led will start flashing, the
display will show a progress bar and the TELEPHONE/MONITOR will start ringing. Otherwise, the led will turn off and the
display will only show a BELL symbol.
§
When trying to call to codes greater than 15 or if the line is busy, we will see two red flashes and the system will return
to its standby mode.
MONITOR COMPACT DIGITAL INTERCOM CON TECLADO
Llamada intercom
Intercom call
introducir código
Enter code
Llamada conserje
Switchboard call
"General Call" enabled. The display will
nt to
l,
Publicidad
