Mounting Main Enclosure Assembly - peerless-AV FPEPM-05 Instalación Y Montaje

Mounting Main Enclosure Assembly

• Do not lift more weight than you can handle. Always use an assistant or mechanical lifting equipment to safely lift
and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to
40 in. • lb (4.5 N.M.) maximum torque.
Hook tilt plate (D) onto bottom socket screws
5
threaded into adapter box (C) and select desired
tilt angle (0° to 15°) as shown in figure 5.1. NOTE:
Be sure split lock washer (I) is on outside of tilt
plate as shown in detail 2.
Insert two M10 x 16 mm socket screws (H) and
two split lock washers (I) through tilt plate (D) and
into top of adapter box (C) as shown in figure 5.2.
Tighten all fasteners using 6 mm allen wrench.
CAUTION
• Do not allow main enclosure assembly to hang freely
on adapter box (C) when all four sets of M10 x 16 mm
socket screws (H) are not fully secured or mount may
come off of pedestal.
WARNING
H
fig 5.2
7 of 24
ISSUED: 11-10-10 SHEET #: 061-9060-3 07-08-15
All other brand and product names are trademarks or registered trademarks of their respective owners.
MAIN ENCLOSURE
ASSEMBLY
D
DETAIL 2
fig 5.1
© 2015, Peerless Industries, Inc. All rights reserved.
C
D
I