Ashley Yandel Power Lift Manual De Instrucciones página 3

FABRIC CARE INSTRUCTIONS
The fabric covering this piece of furniture is very durable for everyday living. It is recommended by the fabric manufacture to only clean this
fabric with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher spots that may have developed. Always check
a small spot of fabric in an area that is unseen to be sure the cleaning agent being used will not discolor or fade the fabric's finishing. Let the
chair air dry and vacuum for the best result.
Chair Assembly
Once the chair has removed from the box, you'll no�ce the back is lying on the top of the seat. Follow the steps below:
1. Some models have back wings that a�ach to the back, when unpacking your chair you will find these back wings packed in the back of
the chair base, Figure A #1 . Please unpack the back wings and set them aside for installa�on later.
2. Locate the RED plas�c bag that contains the power transformer, power cord, four adjustable legs and the control wand. This can be
done by turning the base over on its arms, you will see the RED plas�c bag �ed to the inside of the unit, Carefully cut the �es that hold
the bag remove it. Dispose of the �es and bag properly. Figure A #2
3. With the chair s�ll on its back, remove the 4 adjustable legs from the bag and install them onto the base of the chair and then turn the
chair upright so it is si�ng on the adjustable legs Figure A #3.
4. Remove the control wand from the plas�c bag and connect it to the female plug located in the le� side pocket of the chair, Figure A #4.
Figure A
The Power Button is designed to disable the power operation. It is in the cable that connects the
motor to the transformer. It is a press button. When the button is pressed to the off position, the
Green Light on the Power button will not dis play. When the button is in the on position, the Green
Light in the Power Button will display and the unit will operate.
This Class B digital device complies with part 15 of FCC rules. "Opera�on is subject to following two condi�ons: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired opera�on of the device.
5. To install the back, align the female brackets in the back with the male brackets in the chair base, slide the back down on the base. See
Figure B . Push down on the top of the back to lock the back into posi�on. You will hear a click from each side of the chair to ensure the
back is locked in properly.
SIGNATURE DESIGN BY ASHLEY®
Butt
All Rights Reserved.
May,2019
Page 3 Of 14