WOLFF WS125 18.0V Instrucciones De Funcionamiento Originales página 21

WS125 18.0V
Attach the handle
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attaching/changing the tool
Remove the battery.

Attach the grinding wheel
Press and hold down the spindle

lock (1.).
Using the pin wrench, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the pin

wrench.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the battery.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

Switching on and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
21