Attaching The Shoulder Strap - Scotts LPS40820S Manual Del Operario

Pole Assembly:
Plug the upper section into the lower section.
Pull the locking collar down over the connection and turn
clockwise to secure the two pieces together.
NOTE: Note the polarity markings of the contacts.

ATTACHING THE SHOULDER STRAP

Engage the strap closure ①. Suspend the shoulder strap
in the attachment ②.
INSTALLING/REPLACING THE GUIDE BAR AND CHAIN
DANGER: Never start the motor before installing the guide
bar, chain, chain cover and chain cover lock knob. Without all
these parts in place, the clutch can fly off or explode,
exposing the user to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
WARNING: Before performing any maintenance, make sure
the battery pack has been removed, failure to heed this
warning could result in serious personal injury.
ASSEMBLY
ADJUSTING LENGTH OF TELESCOPIC POLE
Remove the battery pack from the pole saw.

Release the locking colar of the telescopic pole.

Pull the telescopic pole apart until the required working
height is obtained.

Fully retighten the locking colar.
Note: Extend the pole only to the length required to reach
the limb to be cut. Do not extend the handle above waist
height.
NOTE: Adjust hand placement on the shaft of the pole saw
to keep proper balance.
Do not attempt to use pole saw at a length which does not
allow you to maintain proper footing and balance at all times.
WARNING: If any parts are damaged or missing do not
operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury. Call
1-800-618-7474 for assistance.
WARNING: Failure to lock telescopic pole clamp as directed
could result in personal injury.
CAUTION: Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs.
WARNING: Never touch or adjust the chain while the motor
is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain
to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.
6
LPS40820S