Notes; Some Problem And Solved Way - Temper KOBAN KDP-8MW Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

--When you switch on the power, the light will be on at once. And 10sec±3sec later the
light will be off automatically. Then if the sensor receives induction signal again, it can
work normally.
--When the sensor receives the second induction signals within the first induction, it will
restart to time from the moment.
--Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is less than
3LUX (darkness), the inductor load could work when it receives induction signal.
Note: when testing in daylight, please turn LUX knob to
otherwise the sensor lamp could not work!

NOTES:

--Electrician or experienced human can install it.
--Can not be installed on the uneven and shaky surface
--In front of the sensor there shouldn't be obstructive object affecting detection.
--Avoid installing it near the metal and glass which may affect the sensor.
--For your safety, please don't open the case if you find hitch after installation.
--In order to avoid the unexpected damage of product, please add a safe device of
current 6A when installing microwave sensor, for example, fuse, safe tube etc.

SOME PROBLEM AND SOLVED WAY:

--The load don't work:
a. Check the power and the load.
b. Whether the indicator light is turned on after sensing? If yes, please check load.
c. If the indicator light is not on after sensing, please check if the working light
corresponds to the ambient light.
d. Please check if the working voltage corresponds to the power source.
--The sensitivity is poor:
a. Please check if in front of the sensor there shouldn't be obstructive object that affect
to receive the signals.
b. Please check if the signal source is in the detection fields.
c. Please check the installation height.
--The sensor can't shut automatically the load:
a. If there are continual signals in the detection fields.
b. If the time delay is set to the longest.
c. If the power corresponds to the instruction.
www.grupotemper.com
KDP-8MW
Microwave Sensor
(SUN) position,
15

Publicidad

Tabla de contenido
loading

Tabla de contenido