Troubleshooting - Kuvings NJ-9300U Manual De Instrucciones

Care
1
Wash with warm water and a gentle dish
detergent and wipe dry with a dishtowel.
Clean juicing screen with the supplied
brush, do not use a sponge. (Be careful
when you clean the knives)
3
When you wash the juicer, do not use
harsh chemicals. These chemicals may
react with and discolor the juicer.
Tips
.
Most juicer parts are top shelf dishwasher safe, low temperature cycle recommended.
.
For best results hand wash with a soft cloth using mild detergent and towel dry.
.
The juicing screen is hand wash only using the included cleaning brush or similar plastic
bristled dish brush).
.
When cleaning with plastic brushes please note that occasionally bristles get caught in
the strainer - make sure none are left behind before next use.
.
Do not wash any juicer parts with harsh or abrasive cleaners.
.
Please wipe the exterior clean using a damp soft cloth.
.
Do not wash or submerge the juicer body.
6
2
Wipe body clean with a damp towel
and be careful not to get the body wet.
Water in the body can cause
a malfunction or electric shock!
4
Do not store the juicer in direct
sunlight or high humidity
PROBLEM SOLUTION
Safety locking arms will When assembling the juicer the parts must be in alignment or
not lock the arms will not lock. Check that the parts are aligned before
locking the arms. The parts will only fi t in the orientation
shown in the manual – do not force the locking arms shut if
parts are misaligned.
Juicer vibrates excessively Stop the juicer and reassemble the juicer properly. In particu-
lar, make sure the juicing screen is properly seated and no
parts are broken.
Juice is leaking from Juice may leak out if the pulp container is not fi tted properly.
juice cover outlet during Please make sure the pulp container is locked into place.
juicing
Motor has slowed down Too much produce is being fed into the juicer at once. Let the
juicer fi nish processing the produce and be sure to feed more
slowly and/or smaller pieces. Also be sure to use the turbo
setting for hard fruits and vegetables. Stop the juicer and
check that the juicing screen does not have excess pulp build
up – if it does clean juicing screen and be sure to slow the rate
at which you feed produce. Alternating ingredients between
soft and hard produce items can also help.
Motor has jammed Stop the juicer immediately and dissemble and clean the juic-
ing screen. Feed less produce at once to prevent jamming.
Motor stops while juicing Allow the unit to cool down for 2 hours before resuming
or won't turn back on operation.
after extended juicing
Pulp is wetter than usual Stop the juicer and check that the juicing screen is not
clogged. Try juicing at a slower rate.

Troubleshooting

7