OttLite A64PN9 Guia De Inicio Rapido

B
A
LED Multi-Light with Calendar Display
A64PN9 A64009
INS140105
ENGLISH
CONGRATULATIONS!
You've purchased the finest in natural lighting technology with your new OttLite®
product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by
mail, or register online by going to: OttLite.com/warranty.
WARNING: To prevent electric shock, make sure the lamp is not plugged
in until all assembly steps are complete.
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing placing lamp body base (A) flat on a steady
surface.
2. Connect power adapter input (F) into connector (G) in the rear-bottom of
the lamp.
3. Plug the power adapter into a standard household 120V AC outlet.
Note: Only use with the supplied power adapter to avoid damage or fire.
4. Turn the lamp ON & OFF using power switch in touch panel (B) located on
top of base (A).
5. Touch panel (B) includes multiple "touch" keys that control the lamp's light
color mode, brightness within each color mode, and clock settings. This
lamp provides five levels of brightness. See Touch key Instructions section for
operating instructions.
6. To reposition the light, hold base (A) steady and grasp either lamp body (C)
or shade (D) depending on needed adjustment.
7. Refer to Diagrams 1, 2, and 3 for lamp maximum adjustment range.
D
C
NOTE: DO NOT FORCE the shade or lamp body rotation outside allowable
adjustable range as excessive adjustment may cause damage.
Touch Key Panel Instructions:
1. To power lamp and operate LED settings, slightingly touch required "key" to
achieve the following:
• Turn lamp "ON/OFF": touch
G
2. Calendar Setup Instruction:
NOTE: Calendar setting panel is located on the backside of lamp body (C).
F
Diagram 1 Diagram 2 Diagram 3
key as needed
• To adjust brightness: touch or key as needed
• To adjust lighting color mode: touch key to switch light color mode;
3000k°, 4500k°, 5700k°.
• To set calendar touch "S" and hold, the "month" will flash , then touch
key and key to adjust "month", after "month" setting, touch "S"
key again to set the "date", "hour" and "minute".
• After "minute" setting, touch "S" again, "24H" will flash, then touch
and key to select "12H" or "24H" setting.
• After "12/24" hour setting, touch "S" again to activate alarm clock, and
touch and key to set alarm time. Then touch "S" again for return
to normal time mode. In normal time mode, you can touch "S" key to
check the alarm time when alarm clock icon is activated.
LED Multi-Light with Calendar Display
• Calendar icon legend
• S (setting) key – to set calendar.
(up) key – In setting mode, touch to increase.
•
(down) key – In setting mode, touch to decrease; In normal
•
mode, touch to turn ON/OFF the alarm clock.
• Press or and hold to turn off the calendar display;
Press S / / (any key) to turn ON the calendar display.
3. Battery Replacement
• This lamp uses a CR2032 battery. For battery
replacement see Diagram 4. Battery compartment
is located on the backside of lamp body (C).
SAFETY WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS
1. Turn off/unplug and WAIT UNTIL LAMP HEAD (C)
IS COOL before handling.
2. Touch plug only when turning ON or OFF.
3. The LED panel located in shade (D) might get hot after several hours of
continuous use, DO NOT place your hands directly on LED light panel.
4. Never use with an extension cord unless the plug can be fully inserted into the
receptacles in the extension cord.
5. Do not alter the plug.
6. The lamp head included with this unit cannot be replaced by the consumer.
NOTE: The important safety instructions appearing in this instruction sheet are
not meant to cover all possible conditions and situations that may occur. It must
be understood that common sense, caution, and care must be used with any
electrical product.
CAUTION!
If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer or its service agent
or a similar qualified person in order to avoid a hazard. Indoor use only.
FCC PArT 15
NOTe:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that of the
receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any change or modification to product not expressly
recognized by OttLite Technologies voids OttLite's responsibility for proper function
of product.
POwer AdAPTer sPeCIFICATION:
Input: AC 100-240V, 50/60 Hz, 0.5A
Output: 12V DC, 1500mA with a Male DC Plug
THIS LAMP CONTAINS a 5V-500mA USB output port located on the bottom
rear of lamp. USB port can charge such items as ipad, iphone, etc.
T7
Diagram 4
REV041014