La-Z-Boy Silver Luxury-Lift Instrucciones De Operación página 4

Silver Luxury-Lift
Assembly Instructions
NOTICE
– To reduce the risk of product damage:
• Do not plug the transformer in until instructed.
• Never operate the unit until the shipping cable tie has been removed from the mechanism.
1. Choose a location for the lift chair that is close to an electrical outlet.
2. Starting with the unit removed from the carton and unpacked, lay the back across the chair arms
with the back cushion facing the seat, and turn the outside back cover over, toward the front of the
chair. Cut and remove the shipping cable tie securing the mechanism assembly, located at the rear
of the mechanism (F 1).
IGURE
3. Cut the cable tie securing the hand wand, power cord and power transformer box to the inside
of the back (F 3). Remove the hand wand from the packing and set the other parts aside.
IGURE
4. Connect the hand wand. Locate the black round connector at the rear of the body (F
the arrow on the hand wand connector to the arrow on the body connector, push the connectors
together and close the locking cover to secure the connection (F
the seat, toward the front of the chair.
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
5. Install the back.
Turn the locking levers, located on the brackets attached to the back (one on each side),
•
to a 90 degree angle (F 3).
IGURE
Note the location of the fastening tape sewn to the back cover; the mating fastening
•
tape is on the bottom side of the rear rail. Do not attach the fastening tape at this time.
With the back across the chair arms, lift the back at a slight angle and align the brackets
•
on the back with the brackets on the body (F
Lower the back onto the body, making sure the back and body brackets are completely engaged.
•
- Lift the back upholstery cover to visually confirm that both sets of back and body brackets are
engaged (F 4). If one or both brackets are not engaged, remove the back and repeat the
IGURE
steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
Lock the brackets by using a screwdriver to push down the locking levers (F
•
(Assembly Instructions Continued)
6
Power Recliner
®
3), align
IGURE
2). Lay the hand wand across
IGURE
3).
IGURE
dealer for assistance.
®
5).
IGURE
Silver Luxury-Lift
Assembly Instructions
F 1
IGURE
Shipping Cable Tie
F 3
IGURE
Hand Wand, Power Cord
and Power Transformer Box
F 4
IGURE
Back and Body
Brackets Engaged
Power Recliner
®
F 2
IGURE
Hand Wand Connection
Locking
Back
Lever
Bracket
Body
Bracket
Body
Body
Bracket
Bracket
Hand Wand Connector
at Rear Body
F 5
IGURE
Back
Locking Bracket
Lever
Locked
Position
7