Parts & Assembly - Nostalgia Products MMA900 Instrucciones Y Recetas

PARTS & ASSEMBLY
Parts
Power / Function
Selection Buttons
Ice Shaving Chute
Ice Compartment
Lid
Ice Shaving
Blending Gear
Chamber
Assembly
Before first use, thoroughly wash all parts by following the
instructions under CLEANING AND MAINTENANCE.
1. Screw the Blending Blade into the Blending Base. Be sure rubber washer is in place.
2. Set the Pitcher Lid onto the mouth of the Pitcher.
NOTE: The Ice Shaving Chute moves up and down to allow for the insertion of the pitcher.
Tip the pitcher slightly as you insert the mouth of the pitcher under the Ice Shaving Chute,
pushing upwards and simultaneously set the Pitcher base onto the Blending Gear.
3. Ice Compartment Lid can be opened by pushing inward on the
tab located on one side of the clear lid and lifting.
4. Ice Tray can be removed by pushing inward on the tab located at the rear of the unit and
lifting. To replace, insert the front of the Ice Tray into the notches at the front of the unit
and snap the back of the Ice Tray into place. The Ice Tray should fit smoothly into place.
Now you are ready to enjoy cold, refreshing margaritas and
drinks from your MARGARITA & SLUSH MAKER!
5
Water Reservoir
Cord Storage
Base
Blending
Blade
Pitcher
Pitcher Lid