Setting At Work - Beper 50.980 Instrucciones Para El Uso

LEGEND
1. General switch and outlet supply
2. Heating on/off switch
3. Suction/blowing on/off switch
4. Heated ironing surface
5. Suction motor
6. Blowing motor
7. Power supply cable
8. Iron-rest base
9. Iron connection outlet
10. Release and height adjustment lever
11. Foot pedal control (if provided)
12. Motors case
13. Balancer for product adjustment to the floor
OPENING OF THE IRONING WORK STATION
• Arrange the ironing table vertically with the top downwards.
• Open the ironing table pushing with one hand against the sliding frame. Make sure the frame is
engaged in one of the height adjustment notches.
• Gently pull the ironing table to the correct working position
• Act on the eccentric and adjustable balancers (13) by turning the same until the complete
flatness of the product is reached.

SETTING AT WORK

1. Lay the ironing system on the iron-rest base.
2. Connect the supply cable of the board (7) to the wall outlet.
3. Connect the plug of the iron to the outlet (9)
4. Turn on the general switch (1) that supplies the plug (9).
5. Turn on the switch (2) controlling the board heating.
6. The suction or the blowing function can be activated in 3 different ways, according to the
ironing board model you have bought:
a) By means of a switch (3). Commutate the switch (3) from the central OFF position
to activate the suction or the blowing function.
b) By means of a foot pedal control (11). Select the suction or the blowing function
y acting on the switch (3). The motor fan is activated by pressing down the foot pedal
(11) and remains on until the same is released.
7. Turn on the iron or the ironing system following the manufacturer's instructions. When the iron
is ready, it is possible to start ironing operations.
END OF IRONING
• At the end of ironing operations, start the suction motor for approx. 1 min.; this in order to
eliminate every trace of humidity from the board.
• Turn off switches (1) and (2).
• Disconnect the board plug (7) from the wall outlet and the iron plug from the outlet (9).
• After having removed the iron from the iron-rest base, put back the supply cable and the foot
pedal control (if provided) rolling them around the motor case (12).
9