Publicidad
10
10
This hole must be closer
to the notch than the hole
on the opposite surface.
D
BLACK 1-7/8" FLAT HEAD SCREW
Carefully stand the lower portion of your unit upright as shown.
Insert four METAL PINS (Z) into an UPRIGHT (I).
Insert the METAL PINS (Z) in one end of the UPRIGHT (I) into the holes in the BOTTOM (J).
Fasten the LOWER SHELF (M) to the SMALL UPRIGHTS (F2 and H2). Use four BLACK 1-7/8" FLAT HEAD SCREWS (FF).
NOTE: Be sure the METAL PINS (Z) in the UPRIGHT (I) insert into the holes in the LOWER SHELF (M).
Page 14
Notch
M
Unfi nished
edge
J
H2
FF
(4 used in this step)
www.sauder.com/services
I
B
F2
Z
413044
Publicidad
