Interplex RS-003 Standard Manual De Instrucciones página 12

9
Periodically inspect all fasteners associated with the mounting system. Tighten or adjust fasteners as necessary for
optimal operation and safety.
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment.
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Do not use steel wool or other abrasive material.
4. Damage caused by the use of unapproved substances or processes will not be warranted. It is recommended
that you test any cleaning solution on a small area of the mounting assembly that is not visible to verify
compatibility. Refer to compatibility table above.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off the assembly
immediately, using water dampened cloth. Dry the assembly thoroughly after cleaning.
CAUTION: Interplex makes no claims regarding the efficacy of the listed chemicals or processes as a means for
controlling infection. Consult your hospital's infection control officer or epidemiologist. To clean or
sterilize mounted devices or accessory equipment refer to the specific instructions delivered with those
products.
Mild detergent or soapy water
10% bleach solution (10%bleach,90%water)
70% lsopropyl Alcohol
70% Ethyl Alcohol
Hydrogen Peroxide(3%)
Fasteners and Tools Description
NO.
(1) M8 × 25mm Hex Head Cap Screw
(2) 5/16 Split Washer
(3) 5/16 Flat Washer
(4) M5 × 10mm Pan Head Screw
5520000001 Rev A
Routine Maintenance
Cleaning the Mounting Assembly
Chemical Compatibility
Part Description
Acetone
Trichloroethylene
Steel wool or other abrasive material
Ethanol 100%
Oxivir® TB
NO. Part Description
(5) M5 × 20mm Pan Head Screw
(English)
Page 12 of 31