Publicidad
Step 4
Fasten the UPPER BRACE (E) to the UPPER BRACE
å
MOLDING (Q). Tighten three TWIST-LOCK® FASTENERS.
www.sauder.com/services
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Q
E
158015
®
FASTENER
Dowel end
These surfaces
should be even.
Page 9
Publicidad
