Environmental Protection - EDM 08707 Manual De Instrucciones

MOUSE SANDER 105W
OPERATING INSTRUCTIONS
Always ensure the plug is removed from the power
socket before carrying out any adjustment servicing or
maintenance.
Press the I to switch on and the 0 to switch off.
Ensure the on/off switch (1) in not switched on before
plugging the sander in.
Make sure the work piece cannot move or slip. Use
clamps if necessary.
The sander must be used with suitable sanding
sheets. These are attached by pressing into place.
The sander must be switched on before making
contact with the surface to be worked. Do not place
undue pressure on to the sander.
Lift the sander off the surface before stopping the
sander.
Ensure the sander has fully stopped before putting
the sander down to rest.

Environmental Protection

This product is marked with the selective sorting symbol on waste electrical and electronic equipment. This means
that this product should not be disposed of with household waste but must be supported by a collection system in
accordance with Directive 2012/19/UE. It will then be recycled or dismantled to minimize impacts on the
environment, electrical and electronic products are potentially hazardous to the environment and human health
due to the presence of hazardous substances.
EN INSTRUCTION MANUAL
Connection to Power Supply, Cabling, Fusing, Socket
and Earthing Requirements.
Voltage
Before operation of the appliance check that the
voltage in this manual is the same as the supply
voltage.
Cabling and Fuse
This tool is fitted with a two core flex, plug and fuse.
Always replace the fuse with one of identical rating.
If the supply cord of this power tool is damaged it
must be replaced by a specially prepared cord by a
suitable competent and qualified person.
The appliance is a class II device and does not
contain an earth.
Keep the cable away from heat, oil and sharp
edges.
Check the cord for damage before use.
REF. 08707