Troubleshooting Guide - NuTone 88327 Instrucciones Para La Instalacion Operacion

PREPARING THE RECEIVER
REMOVING THE RECEIVER COVER
1. Gently push up on the chimes' cover to disengage the cover from
the base and pull cover away from base.
2. Set battery cover aside.
MOUNTING OF RECEIVER
Refer to Figure 5.
1. Select the desired mounting
location. This location should
be at least 1 foot away from
metal objects and within 100
feet (30 meters) of the chime
transmitter.
2. Drill one 3 ⁄ " hole at the
1 6
desired mounting height.
3. Insert the plastic anchor into
the ⁄ " hole.
3
1 6
4. Drive the upper screw into
the plastic anchor until the
head of the screw extends
approximately 1 ⁄ " from the
8
mounting surface.
5. Place the keyboard slot in the receiver base over the screw
head. Slide the receiver down to secure it.
6. Level the chime receiver on the mounting surface.
7. Mark the mounting surface with a pencil at the center of the
oval hole in the bottom of the receiver base.
8. Gently remove the chime base from the mounting surface and
drill one 3 ⁄ " hole at the previously marked area.
1 6
9. Insert the plastic anchor into the
receiver.
10. Insert the screw through the chime base into the plastic anchor.
Level chime base and tighten screw.
RECEIVER SECURITY CODING
Refer to Figure 6.
Changing the
SECURITY CODE
Security Code is not
SETTING & VOLUME
necessary unless you
have changed the
security code in the
pushbutton.
If you change the
code in the
pushbutton, you
SWITCH
must change the
receiver code to
4 - "D" SIZE
match.
BATTERIES
1. Remove the same
jumpers in the
receiver as in the
pushbutton.
INSTALLING BATTERIES IN RECEIVER
Refer to Figure 6 for placement and polarity (+/-) of batteries. The
NuTone wireless chime requires four "D" size alkaline batteries.
ADJUSTING THE RECEIVER VOLUME
1. Slide power switch to the ON position.
2. Press pushbutton. The red light will light.
3. Adjust volume control to desired sound level. To increase
volume, turn the control clockwise.
1 ⁄ "
8
KEYHOLE
SLOT
CHIME
RECEIVER
FIGURE 5
3 ⁄ " hole and remount the chime
1 6
VOLUME
CONTROL
1
CODE
2
SETTING
3
4
5
6
ON OFF
POWER
+ +
–
– –
+
FIGURE 6

TROUBLESHOOTING GUIDE

PROBLEM
1. Chime does not sound.
2. Chime changes tone.
3. Chime loses volume.
4. Chime is activated by another
wireless device.
5. When pushbutton is pressed, the
incorrect chime sound is heard.
WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that
such products will be free from defects in materials or workmanship for a period of one (1) year from
the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.
During this one year period, NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service. THIS WARRANTY
DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT,
ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not
cover (a) normal maintenance and service or (b) any products or parts which have been subject to
misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty
installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one year period as specified for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE'S OPTION, SHALL BE THE
PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL
NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state. This warranty supersedes all prior warranties.
–
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the
address stated below or telephone 1/800-543-8687, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At the time of
+
requesting warranty service, you must present evidence of the original purchase date.
Date of Installation
Model No. and Product Description
For the location of your nearest NuTone Independent Authorized Service Center:
Product model number • Date and Proof of purchase • The nature of the difficulty
Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field
Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive,
Mississauga, Ontario, Canada L5T 1H9.
Check batteries and polarity.
Make sure receiver or transmitter is not
located on metal surface.
Check receiver and transmitter security
code. These codes must match.
Check batteries in receiver.
Check batteries in receiver.
Change the security code in the
pushbutton and receiver. These codes
must match.
Check the sound code jumpers in the
pushbutton.
One Year Limited Warranty
IF YOU NEED ASSISTANCE OR SERVICE:
Residents of the contiguous United States Dial Free 1-800-543-8687
Please be prepared to provide:
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in U.S.A., Part No. 88327, Rev. 5/01
SOLUTION
Builder or Installer
Rev. 03/2001