Publicidad
Idiomas disponibles
Idiomas disponibles
VERIFYING TONED PAIRS (FIG. 2)
1. To verify you have found the toned pair, connect the Toner-Pro's ABN Test Clips
one end of the cable and initiate a tone.
2. On the other end of the cable, remove approximately 2 mm (3/32") of the outer jacket of each of the wires
believed to be the toned pair.
3. Insert the wire connected to the red ABN Test Clip
in the black ABN Test Clip
Terminal Release buttons
illuminate when the correct pair is inserted.
FIG. 2
TRACING NON-PAIRED WIRES (FIG. 3)
1. Connect the Toner-Pro's red ABN Test Clip
2. Connect the black ABN Test Clip
to the ground, if available). When tracing a shielded cable, connect the red ABN Test Clip to the outer shield,
and the black ABN Test Clip to the center conductor or ground.
3. Turn Toner-Pro on by pressing the Power On/Off button
4. Check the 'CONT' Indicator
5. Turn the Probe-Pro on by pressing the Power On/Off button
6. Select the preferred tone setting using the Tone Mode Up
7. At the far end of the cable, spread the wires at least 2" (51 mm) apart, if possible.
8. Use the Probe-Pro to scan the cable's wire pairs. Move the Probe-Pro's tip
Probe-Pro's volume will increase as it approaches the toned wire.
FIG. 3
OPERATING INSTRUCTIONS
to the "-" (Negative) Terminal
T14
, insert the wire(s) and release (FIG. 2). The Verification Indicator
P13
to the wire to be traced.
T14
to another wire in the cable, but preferably not in the same pair (connect
T14
. If it is illuminated green, you may proceed.
T4
to the "+" (Positive) Terminal
T14
. To access the terminals, press their respective
P11
Press
.
T9
.
P5
or Tone Mode Down
T8
or RJ11 Test Plug
T14
, and the wire curently
P12
will
P14
selector buttons.
T7
slowly across the wires. The
P1
2"
(51 mm)
to
T13
5
Publicidad
