Beper 50.451 Manual De Instrucciones página 6

Cyclonic Vacuum Cleaner Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Description Fig. A
1. Handle
2. Upper cable hook
3. Bottom cable hook
4. On/Off switch
5. Dust container release button
6. Dust container
7. Hepa filter
8. Floor brush
Operation
Warning: this vacuum cleaner sucks only dust: solid objects of size bigger than 2-3 cm can clog the
vacuum cleaner!
Before turning on the appliance, make sure that the Hepa filter and the dust container are correctely
assembled.
Turn the upper cable hook to allow the power cord to release, extend the power cord completely and
check that it is free of tangles.
Insert the plug into an electrical outlet.
Press the power switch on I.
At the end of the suction, switch off the appliance by pressing the switch and positioning it on 0.
Remove the plug of the power cord from the electrical socket. Rewind the power cord on the appro-
priate hooks.
When the powder container fills at approximately 50-60%, it is advisable to empty it and clean the
filter.
Cleaning
The filters are subject to a natural deposit of dirt, which decreases the suction considerably. It is important to
keep them clean in order to improve the efficiency and the life of the vacuum cleaner.
Before doing the following operations, be sure that the vacuum cleaner is turned off (the switch is pushed into
the "0" position) and that the power cord is unplug from the outlet.
When the dust container is full, please empty it.
Note: Use compressed air (compressor or specific air cylinder) in order to clean the Hepa filter. It is
advisable to substitute the old filter for a new one at least once a year.
Hold the open button of the dust container in order to open and close it.
Wash the dust container with warm water and then dry it completely, before replacing it inside the device.
Warning: Do not put the dust container inside the device if it is still wet.
6