First Use Preparation And Set-Up - mspa TUSCANY P-TU049 Manual Del Usuario

REF. NO.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
NOTE: When ordering parts, be sure to quote the model number, part numbers and description.
FIRST USE AND SET-UP PREPARATION
Site preparation and requirements
The spa can be installed indoor and outdoor. For household use only.
The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the maximum
load of the filled spa with listed maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven or unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water.
Provide adequate drainage system around the spa to deal with overflow water and splashes.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
Additional requirements for indoor installation
with a qualified contractor or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of any
other material that could damaged by the moisture.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
Spa liner
Sponge rail
Open-end panel
Plastic wood panel
Heat preservation ground mat
Filter cartridge*2, cartridge base
Spa drain valve adaptor
Inflatable bladder
Wrench
Foot pump and inflation hose for bladder
11
QTY.
1
1
1
1
7
1
1
1
1
1
1
1