Basic Operation; Radio Operation - riptunes CDB200 Manual Del Usuario

BASIC OPERATION

Before You Begin
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the voltage of your
local area.
AC Operation:
Unravel the AC power cord, insert one end into the AC socket on the set, and the other end into a standard AC
outlet.
ATTENTION
1. Do not plug or unplug the power cable while you have wet hands.
2. When planning not to use this unit for a long time, disconnect the power cable from the wall outlet.
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid
shock risks that can be caused by a damaged cable.
Battery Operation:
1. Disconnect the AC cord set completely.
2. Open the battery compartment door and insert 6 "C" size (UM-2 ) batteries(not included) into the
battery compartment.
3. Make sure that the polarities of the batteries ( + ) and ( - ) match those of the battery
compartment.
4. Close the compartment door.

RADIO OPERATION

1. Set the FUNCTION switch to the AM or FM position.
2. Rotate the TUNING control to tune to your desired radio station.
3. Adjust the sound level by rotating the VOLUME control.
4. To turn off the radio, set the FUNCTION switch to AUX/OFF position.
Antenna
For best reception, fully extend the FM Antenna to receive FM stations. For AM reception, the unit has a
built-in antenna. To improve AM reception performance, turn the whole unit until optimal reception is
achieved.
- 7 -