Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
1 Spindle
2 Spindle nut, ball bearing
3 Counter holding sleeve
4 Adaptor M16 x 1.5
5 Adaptor M20 x 1.5
6 Adaptor M22 x 1.5
7 Adaptor M24 x 1.5
8 Adaptor M27 x 1.5
9 Adaptor M30 x 1.5
GENERAL
This set is for easy pulling drive shafts into the wheel hub. The individual tools are made of high
strength steel and the spindle is mounted in a high quality, standard bearings. Through the six
threaded adaptor the set fits on many vehicles such as e.g. Subaru - VW Beetle, VW Touareg,
Porsche Cayenne - BMW E30, E46 - BMW E36 - Mercedes W203 - BMW E32, E34, E38, E39, X5 -
BMW E32, E34, E36
SAFETY INSTRUCTIONS
Use the tool only for its intended use.
Check the tools for damages before use.
Do not use the tool set with any of its parts damaged.
Always keep the threads clean and oil them before use.
Check the thread on the drive shaft. Damaged drive shaft threads must be repaired before the use of
the tool.
USE
Insert the drive shaft joint (G) into the gearing of wheel hub (F).
Mount the required threaded adaptor (E) onto the screw threads of the drive shaft.
Mount the counter holding sleeve (D), spindle (A) and spindle nut with ball bearing (B, C) on the drive
shaft. Rotate the spindle nut to pull the drive shaft into the gearing.
Caution: make sure for the correct seating of the gearing.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
7-piece Drive Shaft Feeder Set
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Art. 8245
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
