Tool it DBT 350 Manual Del Usuario página 8

Translation of the original instructions
OPERATION AND USE
Note: Whenever the tester is connected to a battery, it will perform a quick check of the cable to ensure proper connec-
tion. If the connection is good, the tester will go to the home screen. If the connection is bad, the display will show
«CHECK CABLE». In this case, check the cable connections. The clamps may need to be reconnected to the battery or
the cable may need to be replaced if its ends are damaged.
1- Ensure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries and systems for 12 & 24 V charging (Only 12 volt for START & STOP batteries)
3- Before running a test on the battery, make sure the ignition is off, the accessories are also off. Close all the doors
and the boot.
4- Recommended operating temperature: From 0°C (32°F) to 50°C (122°F)
5- Make sure the battery terminals are clean. If necessary, clean them using a wire brush.
Any presence of oxidation between the tester terminals and the battery connectors or between the battery
connectors and the battery terminals reduces the effectiveness of the tester.
6- Connect the negative (black) terminal to the negative terminal of the battery. Connect the positive plug (red) to the
positive terminal of the battery.
MAIN MENU
Once the clamps are connected, the tester automatically displays the main menu. Use the arrows to scroll through
the main menu features.
Battery test
System test
Vehicle test
Selection of the language
Brightness
BATTERY TEST
1. Select «Battery Test» from the main menu and press «ENTER»
2. Press to select «REGULAR / STANDARD» or «START / STOP»
3. Press button to select the battery type. Press «ENTER» to confirm.
5. Press the key to select the standard (EN, CCA, CA, MCA, JIS, DIN, IEC, SAE, GB)
CCA / SAE : 40~2000
EN: 40~1885
DIN: 25~1120
IEC: 30~1320
JIS: By Battery Type No
CC / MCA : 50~2400
6. Press the button to enter the battery capacity (shown in Ah-hour amp)
7. Confirm the ambient temperature above 0 ° (32 ° F) by pressing «ENTER».
8. Follow the instructions of the tester.
Before starting the test, it is possible to return to the main menu by pressing «ENTER» for 2 seconds.
8
Features
DBT 350
Display screen
1/5
BATTERY TEST
XX.XX V
2/5
SYSTEM TEST
XX.XX V
3/5
IN-VEHICLE TEST
XX.XX V
4/5
LANGUAGE
SELECT
5/5
BRIGHTNESS
Action
Press "ENTER" to do a battery test
Press "ENTER" to test the system
Press "ENTER" to do a vehicle test
Press "ENTER" to change the lan-
guage
Press "ENTER" to adjust the
brightness of the screen.
EN