Troubleshooting - Funtek STX Manual De Usuario

TROUBLESHOOTING

Problem
Short run time
Sluggish action
Do not operate
Poor range
The system will not
Connect
The receiver quits
responding
During operation
Receiver loses
its bind
Possible Cause
• Battery damaged/not charged
• Motor dirty or brushes worn
• Motor dirty or brushes worn
• Bind in drivetrain
• Vehicle battery is not charged
• Transmitter batteries low
• Transmitter powered off
• Vehicle battery is not charged
• Low transmitter batteries
• Receiver antenna damaged
• Transmitter and receiver too near
each other
• Transmitter and receiver too near
large metal objects (vehicles, etc.)
• Receiver accidentally put in bind
mode so receiver is no longer bound
• Low battery voltage
• Transmitter accidentally put in bind
mode, ending bind to receiver
- 7 -
Solution
• Check/change battery
• Check/clean/replace
• Check/clean/replace
• Clean/adjust
• Replace/recharge
• Replace/recharge
• Power On
• Replace/recharge
• Replace/recharge
• Check/repair/replace
• Move transmitter 8–12 feet
(2.4–3.6m) from receiver
• Move away from large metal
objects (vehicles, etc.)
• Rebind transmitter and
receiver
• Completely recharge battery
• Bind transmitter to receiver