Troubleshooting - Signature Design by Ashley 7460212 Manual Del Usuario

This Class B digital device complies to part 15 of FCC rules. "Operation is subject to following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
INSTALLATION OF BACK‐UP BATTERIES
2‐9 Volt back‐up batteries will operate the chair from the reclined position to the seating position one cycle in case of a power failure. If a
power failure occurs and the chair is cycled, the 2‐9 volt batteries will need to be replaced.
1. Remove the sliding door on the side of transformer to locate the 2‐9 volt batteries.
2. Remove the 2‐9 volt batteries and replace with new batteries.
3. Replace door on the transformer.
4. Batteries not included.
TROUBLE SHOOTING
PROBLEM
Chair will not operate
POSSIBLE FACTORS
Transformer may not be connected
SOLUTIONS
Check the transformer has been correctly connected to the socket
Confirm with the wire from chair to transformer is firmly
d
connecte
September,2015
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved. Page 3 Of 14