Publicidad
Idiomas disponibles
Idiomas disponibles
Ballast Assembly Replacement Instructions
Ballast assembly can be replaced without the cutting
of any wires. Use of a qualified electrician is recom-
mended.
WARNING: Turn power off at the fuse or circuit
breaker.
1. Remove plastic cover.
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect re-
placement ballast assembly.
6. Remove two screws and lock washers holding ignitor and ballast
in place.
CAUTION: Ballast is held in place by ignitor.
Carefully remove the ignitor and the ballast together
to avoid personal injury in case the ballast slides
out of unit.
7. Dispose of used ballast assembly.
8. Connect the replacement ballast assembly following steps 1
through 6 in reverse order.
Red
Lamp
Socket
Red
Blue
Ballast
598-1319-02
Model 2LBL8
Photocell
Socket
White
White
Blue
120V AC
Ignitor
Ballast
Ignitor Retention Screw
Input
Reflector
3
Ignitor
Lock Washer
Fixture Housing
Reflector Screw (x5)
Publicidad
