Better Homes and Gardens BH44-084-399-01 Manual Del Usuario página 5

C
Lock Washer
(4 used in this step)
5. Flip the previous assembly upside down on a support surface.
NOTE: Place a protective cover (like the bubble wrap packing material) over the carton or other support
surface to prevent from scratching.
6. Remove the plastic caps from the hanger bolts of Chair Front Legs (C). Attach 2 Front Legs (C) to the
front corner blocks of the Seat Frame (B) by inserting the pre-attached hanger bolts through the drilled
holes on corner blocks, and fit the Flat Washer (4), Lock Washer (3) and Hex Nut (5) onto each hanger
bolt. Tighten the hex nuts with the provided open wrench.
NOTE: DO NOT fully tighten all the nuts until the chair has been adjusted and all the legs are levelled so
that they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
7. Stand the assembled chair upright on a flat surface. Press down the Seat (B) to even all legs. Now,
tightly fasten all bolts and nuts with the provided hex wrench and open wrench.
8. Repeat the same process to assemble the other chair.
Assembly Instructions
C
B
A
(4 used in this step)
③
4
3
5
Flat Washer
④
5
C
C
B
M8 Hex Nut
(4 used in this step)
⑤