Honeywell Home UV100A Serie Manual De Instrucciones página 11

WARNING
UV Light Hazard.
Harmful to skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at bulbs while illuminated.
View illumination only through light indicator
located on lamp handle.
To prevent exposure to ultraviolet light, disconnect
power ultraviolet system before servicing any part
of heating and air conditioning system.
9. Reconnect power to your UV System.
10. Verify that your ultraviolet lamps are operating by
viewing only through the lamp light indicator on the
lamp handle. Never look directly at your lamp while it
is illuminated.
11. Reconnect power to your heating and cooling system.
CAUTION
UV Lamp Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power 15 minutes before removing
ultraviolet bulb(s).
Annual Bulb Replacement
Annual replacement of the bulb in your ultraviolet lamp is
required to maintain effectiveness:
1. Obtain the correct replacement bulb for your unit.
See Table 1.
Table 1. Select a Replacement Bulb/Handle Assembly or
Replacement Bulb.
Replacement
Bulb/Handle
Unit Description
UV100A1000 UC100A1005
Air Treatment
System
UV100A1018 UC100A1054
Air Treatment (two required)
System
UV100A1059 UC100A1054
Surface
Treatment System
UV100A2008 UC100A1054
Surface
Treatment System
2. Disconnect the power to your heating and cooling
system.
SnapLamp™
Replacement
Assembly Bulb
UC18W1004
UC36W1006
(two required)
UC36W1006
UC36W1006
3. Unplug or turn off power to your UV System and allow
the bulbs to cool for at least 15 minutes.
4. Rotate the lamp handle counterclockwise and gently
pull the lamp handle to remove the bulb. See Fig. 5.
5. If you have a SnapLamp™ handle, follow steps 5 and
6; otherwise, proceed to step 7. Grasp the Sna-
pLamp™ handle in one hand and the lamp glass in
the other and pull straight apart. See Fig. 15.
Fig. 15. Disconnect lamp glass from SnapLamp™ handle.
6. Insert the new lamp glass into the SnapLamp™ han-
dle by aligning the key and pushing straight together.
See Fig. 16.
Fig. 16. Replace lamp glass in SnapLamp™ handle.
7. Insert the lamp handle into the base with the lamp
light indicator at the eleven o'clock position. Continue
pushing and gently rotating counterclockwise until
the lamp
handle inserts fully into the base. See Fig. 13.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
View illumination only through light indicator
located on lamp handle.
To prevent exposure to ultraviolet light, disconnect
power to ultraviolet system before servicing any
part of heating and air conditioning system.
8. Rotate the lamp handle clockwise until it snaps into
place with the lamp light indicator aligned with the
raised
button on the unit cover. See Fig. 14.
9. Reconnect power to your UV System.
10. Verify that your ultraviolet lamp is operating by view-
ing only through the lamp light indicator on the lamp
handle. Never look directly at your lamp while it is
illuminated.
11. Reconnect power to your heating and cooling system.
11
UV100A ULTRAVIOLET SYSTEMS
M22851
M22853
68-0248ES—01