Line Installation - Ryobi 720r Manual Del Operador

MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 19
Split-Line™ Installation
8. Take approximately 12 feet (3.65 m) of new trimming
line. Insert one end of the line through one of the two
holes in the inner reel (Fig. 20). Pull the line through
the inner reel until only about 4 inches is left out.
9. Insert the end of the line into the open hole in the
inner reel and pull the line tight to make the loop as
small as possible (Fig. 20).
10. Before winding, split the line back about 6 inches.
Fig. 20
Loop
15