Operating Guide Prepare The Remote Transmitter; Prepare The Receiver Collar - Radio Systems PetSafe HDT11-11049 Guía Para El Uso Y El Amaestramiento

Step
Prepare the Remote Transmitter
1
To Insert and Remove the Battery
1. Hold the Remote Transmitter face down and pull the battery door open (1A).
2. Insert the 9-volt battery with the positive side oriented as shown (1B).
3. Replace the battery door by positioning the bottom edge (1C), and snap the battery door into
place.
1A
To verify the battery has been inserted correctly
1. Press either button on the Remote Transmitter.
2. The Transmitter Indicator Light should come on.
3. If the Transmitter Indicator Light does not come on, you may have inserted the battery
backwards. Try taking it out and turning it around.
4. If the Transmitter Indicator Light still does not come on, contact the Customer Care Center at
1-800-732-2677.
Transmitter Indicator Light – Function and Response
Remote Transmitter Function
Any button is pressed
Low battery
_____________________________________________________________________

Prepare the Receiver Collar

Step
2
Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for
pets with long or thick hair. Tighten the Contact Points with pliers one-half turn beyond fi nger tight
(2A). Check the tightness weekly.
To Insert and Remove the Batteries
1. Remove the screws with a small Phillips screwdriver (2B).
2. For the HDT11-11049 only, push the Battery Lid up according to the arrows stamped on the
Battery Lid (2B).
3. Slide the Battery Lid out.
6
Operating Guide
1B
1-800-732-2677
Transmitter Indicator Light Response
Solid in color
Flashes every 4 to 5 seconds
1C