Publicidad
Idiomas disponibles
Idiomas disponibles
4. HOW TO OPERATE
1. Plug in to 240V outlet.
2. Press ON / OFF button
3. Press the range button (TC) for several times until the desired
power level is reached.
L ----- Thin plastic (bumper etc.)
M ----- To about 5mm thick plastic (spot light etc.)
H ----- Thick or hard plastic
4. Choose suitable heating repair pin and set it to tip of the grip.
5. Please form the part to repair as original shape.
6. Presses the switch button on the grip and hold about 10
seconds until the pin is hot enough to weld. Then press the pin
gently against the place to repair.
WARNING
When heating repair pin is pressed too hard, it may penetrate the object.
Please press by sllght power.
7. When the pin is taken half way to the repairing part, release the
switch button on the grip then wait for a few seconds until repair part
gets firm. After that draw the pin out of the grip.
8. When a repairing part reaches long and wide, please repeat the
procedure at intervals of 1 - 3 cm.
9. Cut off the pin using pliers.
CAUTION
Be aware of fragments. Wear safety goggles when you cut off pins.
10. Grind off the excess of the pins using sander. Apply putty and paint if
you wish to finish the surface more finely.
DISPOSAL
An inappropriate recycling of this device leads to serious danger for our health
and the environment. Never recycle this electrical unit with your domestic waste.
Collect worn electrical devices and recycle them at your local collecting point.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
