ASROCK 4CoreDX90-VSTA Manual Del Usuario página 18

ATX Power Connector
(20-pin ATXPWR1)
(see p.2, No. 3)
ATX 12V Connector
(4-pin ATX12V1)
(see p.2, No. 2)
Serial port Header
(9-pin COM1)
(see p.2 No..25)
2.7 Serial A 2.7 Serial AT T T T T A (SA 2.7 Serial A
2.7 Serial A 2.7 Serial A
This motherboard adopts VIA
ATA (SATA) hard disks and RAID (RAID 0, RAID 1 and JBOD) functions. You may
install SATA hard disks on this motherboard for internal storage devices. This
section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
1 8 1 8 1 8 1 8 1 8
A (SA A (SAT T T T T A) Hard Disks Installation A (SA A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A (SA A) Hard Disks Installation
® VT8237A southbridge chipset that supports Serial
ASRock 4CoreDX90-VSTA Motherboard
Please connect an ATX power
supply to this connector.
Please note that it is necessary
to connect a power supply with
ATX 12V plug to this connector
so that it can provides sufficient
power. Failing to do so will cause
the failure to power up.
This COM1 header
supports a serial port module.