Brandson Equipment 304023 Manual Del Usuario página 32

"AUTO" Mode
The auto function controls the heat output according to the desired tempera-
ture: Once the set temperature is reached, the fan heater controls the power
and maintains a constant temperature in the room. This function enhances your
comfort and reduces the energy consumption.
Press the "UP" and "DOWN" buttons to set the desired temperature. The tem-
perature can be set from 5°C (useful as frost protection) up to 40°C. The default
temperature is set to 30°C.
Timer function
Note: Using the Power OFF Timer function, you can switch off the appliance after
a certain time and it can be set only when the appliance is switched on.
Press the "Timer" button on the control panel of the heater or on the remote con-
trol. The display shows the timer value. Press the "UP" and "DOWN" buttons to
change the number of hours for which the fan heater has to remain switched on,
before the appliance switches off by itself (in 1-hour increments up to a maximum
of 24 hours).
In "AUTO" mode, the selected hours will flash for a few seconds. Then, the corre-
sponding set temperature is displayed again. In the other modes, the timer time
is displayed instead of the "target temperature". The heating is switched off once
the internal clock counts down the set number of hours.
7. Oscillation
The oscillation can be switched On or Off using the oscillation (" ") button.
32
English