Installation Instructions; Part Numbers - Cequent Performance Products 75470 Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

On vehicles without cross bracing members,

This area will need to be cut out to provide

access to trunk pan.

Plastic Trunk

Pan Cover

Plastic

Fascia

Cut plastic trunk pan

Cover in area shaded

For hitch bar clearance

Typical all models

Note: Trunk Pan cover requires trimming. Obtain Vehicle Owner's approval before cutting.

Remove (2) M10 fasteners which secure vehicle cross-bracing members to trunk pan as shown in Figure 2 and return to vehicle

owner.

Remove (4) fascia-mounting bolts which attach fascia to trunk pan as shown in Figure 2. Retain (3) of these bolts for re-

installation (one bolt will not be re-installed and may be returned to vehicle owner). Remove (7) flanged nuts which attach plastic

trunk pan cover to trunk pan. Retain all (7) flanged nuts for re-installation of trunk pan cover.

Remove inboard bumper mounting bolt and flanged nut, one each side, as shown in Figure 1 and return to vehicle owner.

Cut plastic trunk pan cover as shown in Figure 2.

Install M10 x 1.50 x 140mm bolts down thru bumper/bumper mounting bracket, each side, as shown in Figure 1.

Note: There will be sufficient room to use flat wrench to hold bolt head above bumper.

Raise hitch into position as shown. Install conical toothed washers and nuts provided with hitch to M10 fasteners installed in step

Attach forward hitch bar to trunk pan as shown, sandwiching cross-bracing members between hitch bar and trunk pan.

Note: Flat washers must be used as spacers between hitch bar and cross-bracing members.

Tighten all M10 x 1.50 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N-M)

Re-install (7) flanged nuts which attach trunk pan cover to trunk pan. Reinstall (3) fascia-mounting bolts.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2006, 2007, 2009 Cequent Performance Products