Fax +1 305 430 9692
Use it to clean delicate surfaces, furniture, lamps, shelves and
•
books, etc.
Note: remove all the accessories before
attempting to place the vacuum cleaner back
into its base.
After use, you can store the 2 accessories
underneath the base, in their storage
compartment. For this, insert the narrow end of
each accessory first into the storage
compartments.
MAINTENANCE
Cleaning the filter and the dust container after each use is
•
extremely important as it allows for optimal use of your appliance
and eliminates the unpleasantness of bad smells.
Remove the dust container by
•
holding the handle in one
hand, and the dust cup in the
other, then turning both parts
in a twisting motion to unlock
the dust container.
Once separated from the
•
housing, hold the dust container and slide out the filter holder (we
advise you to do this over a dustbin).
Empty the dust container and rinse the filter under cold water.
•
Wait until the filter dries completely before replacing it back into
•
the dust container. Never use the vacuum cleaner if the
container or the filter is still damp!
Insert the filter holder in the dust container. To do so, make sure
•
the ribs in the dust container face the grooves situated on the
edge of the filter holder. The correct position of the filter holder is
extremely important, as it guarantees the tightness between the
dust container and the motor.
If the filter is too dirty or damaged it must be replaced. To do so,
•
please contact customer service of the manufacturer.
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
7
Assembly page 7/32
special
instruction
from
Team
Print only
HVC 39365 - 120501