Dyna-Glo OHIR18LV Instrucciones De Funcionamiento página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

B. Prepare to install the heater wall mounting bracket
as follows:
1. If the wall mounting bracket is to be attached to
a stud and wallboard wall, refer to Figure 3 for
dimensions, locate a stud, and drill two 1/8" pilot
holes into the stud centerline. Use template for
simplified installation.
2. If the wall mounting bracket is to be attached
to a brick or masonry wall, refer to Figure 3
for dimensions. Obtain two 1/4 inch (inside
diameter) expansion anchors and determine the
correct drill size to be used with them. Drill the
appropriate size holes in the brick or masonry to
accept the anchors.
C. Place the wall mounting bracket on the wall and
align the two through holes on the bracket with
the pilot holes or anchors. Install 1/4 inch by 2-1/2
inch lag screws through the bracket into the stud or
anchors. Tighten securely.
D. Locate heater mounting clip on back of heater and
select the 1/4" – 20 by 3/4" hex head bolt and 1/4" -
20 hex nut.
24" (610mm) MIN
9" (229mm)
GAS FIRED INFRA-RED WORKSHOP HEATER
Figure 3. Heater Mounting Information
HEATER WALL
MOUNTING
BRACKET
1/4" X 2-1/2" LONG
LAG SCREWS
(2 REQUIRED)
CONTROL
58" (1473mm)
E. Position the heater as shown in Figure 3 and slide
the heater mounting clip over the bracket and install
the bolt through the clip and bracket.
F. Thread the hex nut onto the bolt and tighten
securely.
G. Ensure that the selected thermostat location
meets all of the above requirements. Refer to the
instructions that come with the thermostat for
additional grounding information and mounting
instruction.
H. If the wall is of stud and wallboard construction,
then use the #6 by 1 inch sheet metal screws,
included with the thermostat, and mount the
thermostat in the selected location.
I. If wall is brick or masonry, the appropriate
anchors must be obtained to accommodate
thermostat mounting screws. Use the back plate
of the thermostat as a template to mark the hole
locations, drill appropriate size anchor holes, install
the anchors, securely attach the thermostat using
the mounting screws.
J. Connect thermostat wires to gas valve as shown in
Figure 4.
CEILING
1/4"-20x3/4" HEX-
HEAD BOLT
GAS
VALVE
1/2" NPT GAS INLET
(DO NOT EXCEED 1/2 PSI)
THERMOSTAT CABLE
(SEE FIGURE 4)
#6 X 1" SHEET METAL SCREWS
(2 REQUIRED - INCLUDED WITH THERMOSTAT)
THERMOSTAT (SEE INSTRUCTIONS
INCLUDED WITH THERMOSTAT
FLOOR
MOUNTING
FLUE
CLIP
DEFLECTOR
HEATER
REFLECTOR
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ohir22nvOhir30lvOhir33nv

Tabla de contenido