Troubleshooting Guide - TOPDON Volcano2000Pros Manual Del Usuario

Important
The battery jump procedure is only for use on vehicles with 12 volt batteries.
Use only the smart battery clamps supplied with this product.
Only jump start the vehicle when capacity is at least 50%.
Better not get the two battery clamps contacted together.
If the engine does not start, disconnect this product from the vehicle battery, and wait for
at least 20 seconds before reconnecting. Maximum three attempts are allowed in 2 minutes.
Once the vehicle engine is successfully started, disconnect the clamps within
30 seconds.
DO NOT use this product if any cable, clamp or cord is damaged.
DO NOT put the product under the direct sunlight or hot areas.
DO NOT disassemble the equipment.
DO NOT use chemicals or detergents to clean the product.
DO NOT place the products in high temperature environment for a long time.
Check the charge level of the device every four months, and charge the device if needed.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
14
conditions: (1) This device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help

Troubleshooting Guide

Q: How to turn off this product?
A: This product will automatically power off while not being used.
15