Ecco 5350 Serie Instrucciones De Instalación Y Operación página 4

Maintenance:
Most strobe failures can be traced to wiring or battery prob-
lems. Check all wiring and connections to insure the correct
voltage is reaching the strobe light. If the strobe operates
erratically or stops completely, and the wiring is not at fault,
the flashtube is probably worn. To replace it, remove the outer
dome. Unscrew and remove the inner lens. Remove the flash-
tube by squeezing on the tabs on the side of the tube holder
and pulling up. Plug in the new tube assembly. See Figure 4.
Note: The connector is keyed to ensure proper orientation.
Make sure that the three contacts on the bottom of the flash-
tube are straight. Do not force. If trouble continues, return
product to your local dealer for warranty replacement, or call
ECCO Customer Service for assistance (800) 635-5900.
PRESS IN ON TABS
AND PULL UP
Replacement Parts/Accessories:
Description
Replacement Dome Lens, Amber
Replacement Dome Lens, Blue
Replacement Dome Lens, Clear
Replacement Dome Lens, Green
Replacement Dome Lens, Red
Replacement 4" Lens, Amber
Replacement 4" Lens, Blue
Replacement 4" Lens, Clear
Replacement 4" Lens, Green
Replacement 4" Lens, Red
Flashtube
920-5200-00 Rev. E
FIGURE 4
!
WARNING!
The strobe power supply is a high voltage device. To avoid
the risk of electrical shock, wait 5 minutes after turning off
power before removing lens for access to internal parts of
the strobe heads.
Note:
Operating the vehicle without the lens installed on
this product will result in damage that will not be covered
under warranty.
Part No.
R5300LA
R5300LB
R5300LC
R5300LG
R5300LR
R6050LA
R6050LB
R6050LC
R6050LG
R6050LR
A5300VMK
Page 4 of 5