LifeFitness 95R Lifecycle Instrucciones De Montaje página 6

6. Position the HANDLEBARS (7) as shown. Secure each HANDLEBAR to the SEAT
FRAME (N) using two M8 x 20mm SCREWS (8) and two M8 WASHERS (9) each.
NOTE: Be sure the the TABS of the HANDLEBARS are inserted into the slots on the
underside of the SEAT FRAME as shown in the detail before securing.
Connect the HEART RATE CABLES (O) leading from the HANDLEBARS to the
CENTER LEAD (P) located in the SEAT FRAME.
NOTE: Be sure the CONNECTORS are fully seated.
7. Secure the ACCESSORY TRAY HOLDER (10) to the SEAT FRAME (N)
using two M8 x 16mm SCREWS (11) and two M8 WASHERS (9). Tighten
the SCREWS securely. Do not overtighten the SCREWS.
Secure the SEAT (12) to the SEAT FRAME (N) using four M8 x 20mm
SCREWS (8) and two M8 WASHERS (9). Tighten the SCREWS securely.
Do not overtighten the SCREWS.
Place the ACCESSORY TRAY (13) into the ACCESSORY TRAY HOLDER
as shown. Press down firmly to secure the ACCESSORY TRAY in place.
8. Attach the SEAT BACK (14) to the SEAT FRAME (N) using four SCREWS
(15). Tighten the SCREWS securely. Do not overtighten the SCREWS.