Step 12
Unfold the LEFT BACK (G) and lay it over your unit.
å
Make equal margins along the top and outer edge of the
å
LEFT BACK (G). Push on opposite corners of your unit if
needed to make it "square".
NOTE: The LEFT BACK (G) will overlap the RIGHT BACK (F).
å
Follow the enlarged diagram.
Fasten the LEFT BACK (G) to your unit using three BLACK
å
9/16" LARGE HEAD SCREWS (1S) into the holes shown in
the LEFT BACK. Use fi fteen NAILS (1N) into the top and
both side edges.
(15 used in this step)
Page 16
1N
NAIL
F
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Notch
G
G
F
The LEFT BACK (G) will
overlap the RIGHT BACK (F).
418295
Do not tap NAILS into
the bottom row of holes.
BLACK 9/16" LARGE HEAD SCREW
(3 used in this step)
www.sauder.com/services
1S