Installation Instructions - Cooper Lighting VT100G Instrucciones

INSTALLATION INSTRUCTIONS

Please Read these instructions carefully before proceeding with the installation
of this product. Failure to follow instructions may result in improper operation or
void the warranty.
WARNING: Risk of Electric Shock. Disconnect power at fuse or
circuitbreaker before installing or servicing.
outdoor lighting service only and should not be used in enclosed or improperly
ventilated areas with a high ambient temperature. This product must be wired in
accordance with the National Electrical Code and all applicable local codes and
ordinances. Proper grounding is required to ensure personal safety. All work
should be done by a qualified electrician.
MOUNTING
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit
breaker before installing or servicing.
Note: Make certain that the fixture is connected to a 120V power
source. UL approved wire connectors should be used. Be sure no
loose strands of wire are sticking out from under your wire connectors.
1. Unscrew guard (if applicable) and glass lens.
2. Remove two screws on socket plate. Mount housing to either
1/2˝ hanging conduit or to a surface using the two tabs and
screws provided.
WIRING
1. Connect the white house supply wire to the white fixture wire using a wire nut
(not supplied). Connect the black house supply wire to the black fixture wire
using a wire nut. Connect the house supply ground wire to the green ground
screw in the housing.
2. Attach socket plate to the housing and fasten securely with screws,
making sure no wires are sticking out from underneath the housing.
3. Screw in lamp, glass lens and guard (if applicable).
4. Turn on power at main fuse/breaker box.
MAINTENANCE
WARNING: Risk of Electric Shock. Disconnect power at fuse or
circuit breaker before installing or servicing.
Always replace bulb with the same or lower wattage than the bulb included.
Installing a higher wattage bulb could create a fire hazard and shorten the life of the
bulb. Use of higher wattage bulbs will void the warranty.
Note: If lens is replaced, use only tempered safety glass of equal thickness.
For assistance, call 1-800-334-6871 or e-mail us at ConsumerProducts@cooperlighting.com
This fixture is designed for
2
English
VT100G
CVT100G